今天你会创建一个破解代码的游戏！该程序会创建一个模式，玩家将尝试找到
如果你选择的颜色正确，并且排在正确的位置，右侧所示的点将为黑色。
如果你选择的颜色正确，但排在错误的地方，显示的点将是白色。
如果选择的颜色不在秘密代码中，则不会有相应的点出现。
To navigate the page using the TAB key, first press ESC to exit the code editor.
今天你会创建一个破解代码的游戏！该程序会创建一个模式，玩家将尝试找到
如果你选择的颜色正确，并且排在正确的位置，右侧所示的点将为黑色。
如果你选择的颜色正确，但排在错误的地方，显示的点将是白色。
如果选择的颜色不在秘密代码中，则不会有相应的点出现。
To navigate the page using the TAB key, first press ESC to exit the code editor.
Your micro:bit is not set up for this program. Follow these steps to use your device with Codesters:
Your micro:bit has an old version of the Codesters binary file. Follow these steps to update the file on your micro:bit:
Warning: This will erase any existing program on your micro:bit.
Having trouble? Check out the micro:bit instructions to update your firmware.
Setting up your micro:bit
Calibrate your micro:bit by tilting it until all the LEDs are lit.
For a demonstration see the micro:bit calibration instructions.
Try the following steps to connect to your Micro:bit:
1. You may need to reload this page and try your program again.
2. Try disconnecting and reconnecting your Micro:bit. Then reload the page and run your program again.
3. If you are still having problems your Micro:bit may have an old firmware version that is incompatible with Codesters.
To update the firmware follow these Micro:bit instructions.
Are you already running a Codesters project in another tab or window?
Micro:bit can only connect to one web page at a time. Try stopping other Codesters projects or closing other tabs or windows that may be using your Micro:bit.
If that doesn't fix the problem try disconnecting your Micro:bit, reloading this page, and reconnecting your Micro:bit.
Status: Connected!
Status: Connecting...
Status: Still connecting...
Status: Failure
Status: Not Found
Is your Micro:bit connected?